DoubleSight DS-25SWA Manuel télécharger pdf

Slat Rail System - Monitor Arm & Bracket Installation

S te p 1 - Loosen bolt on top edge of Bracket with provided wrench as shown.

Install Bracket onto Slat Rail in desired position. Tighten in place.

Slat Rail Monitor Arm Installation

S te p 2 - Install the Monitor Arm onto the bracket. Tighten Arm in place with

provided wrench.

S te p 1 - Lay monitor on flat level surface.

VESA Plate/Monitor Installation

S te p 2 - Using 4 monitor screws secure VESA plate to back of monitor.

S te p 3 Install Bracket / Monitor into end of Arm.

Monitor cables may be threaded through the arm. Cable guides snap off/on to

allow placement of cables.

Cable Management

S tep 1 - Arm Tension can be adjusted using the M4 Allen Wrench at the base

of the upper arm.

Arm Adjustment

S tep 2 -

Arm should be held in horizontal position while adjusting tensions as

shown. Turn wrench in the direction of the arrows to increase or

decrease tension. Increase for heavier monitors, decrease for lighter

models.

S tep 3 - VESA Bracket swivel tension can be adjusted at the base of the

bracket using the M3 Allen Wrench.

For questions about your DoubleSight Flex Monitor Stand please contact DoubleSight Customer Support at 888.897.8869 or [email protected].

www.doublesight.com

Note : Leaving the bolt slightly loose will allow you to adjust the bracket left or right.

Note : An allowance of extra cable should be left to accommodate arm movement.

This Monitor Arm may be wall mounted. Simply remove back plate from Bracket

and screw directly to wall or post as shown.

Alternate Installation

3-1

3-2

1 2

Page 1

Slat Rail System - Monitor Arm & Bracket InstallationS te p 1 - Loosen bolt on top edge of Bracket with provided wrench as shown.Install Bracket o

Slat Rail System - Monitor Arm & Bracket InstallationS te p 1 - Loosen bolt on top edge of Bracket with provided wrench as shown. Install Bracket

Pas de commentaire

DoubleSight DS-25SWA Manuel